Reference
Letter height from reading distance, and the back of the room
Two calculators. One sizes the letters on a sign from how far away it is read. One sizes the smallest type on a slide for the back row of a room. Both use the same published rate, and the page says exactly what that rate is and is not.
Assumptions behind the numbers
- The sizing rate is Table 703.5.5 of the 2010 ADA Standards for Accessible Design, published by the U.S. Access Board: 5/8 in at a viewing distance under 72 in, plus 1/8 in per foot of viewing distance beyond 72 in, for characters mounted 40 to 70 in above the floor. The two higher mounting bands start at 2 in and 3 in.
- Character height is measured on an uppercase I, from its baseline to its top (ADA 703.5.5). It is not the type size you set in a menu: a typeface's cap height is always smaller than its point size, and the amount differs by typeface.
- Viewing distance is the horizontal distance between the character and whatever stops a reader getting closer (ADA 703.5.5). Pace it; do not guess it.
- Those Standards apply to signs in buildings and facilities covered by the ADA. Outside that scope this tool is applying a published rate, not a requirement. No standard we found sets a minimum letter height for a yard sign, a flyer or a slide.
- The points figure is the cap height converted at 72 points to an inch. Because cap height is smaller than point size, the type size you set has to be larger than the number shown; the page says to test one letter rather than trust the conversion.
- The back-of-the-room calculator is arithmetic from a sign table applied to a screen. No font-metric ratio is assumed anywhere, which is why it reports a cap height and a fraction of the image rather than a point size.